Troubleshooting; General - Hisense HSGP15FB User Manual

Troubleshooting

Error messages
F10 Overfilling water
F11 Water outlet fault
F12 Water inlet fault
F40 Inlet valve leakage
F41 Heater fault 1
F45 Diverter fault
F52 Water level fault
F54 Overfilling water
F56 Circulation pump fault
F67 Water inlet fault
F68 BLDC drain pump fault
Press any button to clear the error message.

General

Problem
The display does not react when
pressed.
Action
Unblocking the drainage pump. See the chapter, Care and clean-
ing. If the problem persists, contact your nearest service centre.
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Check whether dishwasher inlet hose is connected to a pressure
limiting valve (some pressure limiting valves may restrict the supply
of water to the dishwasher).
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter, Care and cleaning. If the problem persists, contact
your nearest service centre.
Turn the water tap off and contact your nearest service centre.
Turn the water tap off. Remove the plug from the wall socket and
contact your nearest service centre.
Contact your nearest service centre.
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, contact your
nearest service centre.
Turn the water tap off and contact your nearest service centre.
To avoid water leaking outside the dishwasher, do not remove the
plug from the wall socket until the water tap on the supply line
has been turned off!
Contact your nearest service centre.
Check whether dishwasher inlet hose is connected to a pressure
limiting valve (some pressure limiting valves may restrict the supply
of water to the dishwasher).
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter, Care and cleaning. If the problem persists, contact
your nearest service centre.
Contact your nearest service centre.
Possible causes
You have pressed the display
too soon after closing the door.
The door is open.
Action
Wait a moment then try again.
The display only reacts to use
when the door is closed.
27