If you want to load more dishes
Press and hold
for three seconds to pause the program. Open the door. Add the dishes and close
the door. Press
.
If the dishwashing program was remote started, the interrupted program will continue once the door
is closed. You can monitor the dishwasher using the ConnectLife app and remote stop the program,
although you will not be able to remote start it again.
Power failure
If the dishwasher is turned off due to a power failure when a dishwashing program is running, the
program continues when power is restored. If the power is cut during drying, the program is interrupted.
If the dishwashing program was remote started and has not ended, the program will continue once
power is restored. You can monitor the dishwasher using the ConnectLife app and remote stop the
program, although you will not be able to remote start it again.
If the door is open for more than 2 minutes during drying, the program is interrupted.
Once the program has finished
Once the program has finished, "End" appears on the display.
At the end of the program, you will hear a short beep. Chapter Settings describes how to change this
function.
The dishwasher switches off automatically after the program ends. Turn off the water tap after each
use.
For the best drying results
Fully load the dishwasher.
Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important
for plastic items.
Top up with rinse aid or increase the rinse aid dose setting.
Activate the
Auto Dry option.
Open the door a little once the program has finished.
Allow the dishes to cool before unloading the dishwasher.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from the upper basket falling onto the dishes
in the lower basket.
1)
You should not load more dishes if the lid of the detergent dispenser has been opened.
1)
17