Table of Contents
Advertisement
Placing the dishwasher
The dishwasher can be installed under a worktop or freestanding. Make sure the area on which the
dishwasher is to be installed is firm.
Adjust the height and slide the dishwasher into place
Freestanding
Make sure the surface on which the dishwasher is to be installed is firm. Adjust the dishwasher's
height using its four feet so that the dishwasher is level. The dishwasher may not lean more than
5 mm.
Built-in
1. Start by measuring the height from the floor to the bottom edge of the worktop.
2. Measure the height from the floor to the top edge of the dishwasher.
3. Adjust the dishwasher's feet by turning them clockwise to raise or anticlockwise to lower the
machine.
4. Check that there is an air gap of at least 3 mm between the underside of the worktop and the top
edge of the dishwasher.
5. Slide the dishwasher into place.
Pull through the drainage and supply hoses when the machine is slid into place.
Check that the hoses have no kinks or sharp bends, and check that there is nothing that can
damage the hoses.
Check that the machine is installed such that the door opens freely, otherwise door lock
functionality may be disrupted.
6. Make any final adjustments to the front feet (the dishwasher may not lean more than 5 mm).
The dishwasher can also be installed in a recess without its worktop. See Remove dishwasher worktop.
Drainage connection
This dishwasher is suitable for installing in a raised recess (to attain an ergonomic working height).
This means that the dishwasher can be placed so that the drainage hose runs to a lower level than
the bottom of the dishwasher, such as by routing it directly to a floor drain. The dishwasher is fitted
with an integrated anti-siphon device to prevent the machine from being emptied of water during the
wash cycle.
34
24 mm
Advertisement
Table of Contents
