Momento Coffee & Milk; Setting The Water Filtration System; Change The Water Filter; Descaling - Nespresso Momento Coffee User Manual

9.2. Momento Coffee & Milk

9.2.1. Setting the water filtration system

filter

9.2.2. Change the water filter

filter

9.2.3. Descaling

descale
EN . 44
water filter installation
yes
would you like to install a water
filter?
no
The machine can be installed without
water filtration. Refer to the descaling
table for frequency. Follow the instruc-
tions on the screen to set the water
filter.
The water tank should be cleaned every time the filter is changed (or at least weekly in the direct water connection
mode). There are 3 possible options to set the water hardness: A, B, C. Refer to "Descaling intervals and water filter
exchange" on page 43.
To complete the new water filter installation, the machine will automatically perform a rinsing cycle of approximately
0.5 litres through the outlets, to ensure optimal performance. Therefore, place a container with enough capacity under
the outlets.
1
insert capsule
filter
hot foam hot water hot milk
When the "filter" symbol appears
in red the internal filter should be
changed. Tap on the red filter symbol
and follow the instructions.
3
Once the water hardness is set,
remove the water tank and its lid.
Rinse with fresh drinking water.
Remove the old water filter.
In case the "clean" and "descale" symbols appear in red at the same time, proceed first to the cleaning procedure and
then to the descaling procedure.
min
The water tank shows different desca-
ling marks. Refer to bottom marking
when descaling the coffee system.
Refer to the higher marking when
descaling the milk system.
setup menu
set water hardness
set water filter installation
If the machine is already installed,
you can go to the setup menu > "set
water filter installation" to change the
setting.
Alternatively, when the "filter"
i
symbol appears in red, you can
start the water filter change
procedure by entering the
maintenance menu.
Select "change the internal filter"
and follow the instructions.
4
Fill a receptacle with fresh drinking
water. Immerse the new water filter
completely and squeeze it several
times until all air bubbles have been
removed.
If the machine is equipped with a
water filter, always remove it before
descaling.
Alternatively, an external filtration
i
system can be installed by a
Nespresso service partner if the
machine is installed with a direct
water connection.
2
water filter installation
Follow the instructions on the screen
to set the water hardness on both the
machine and the new water filter.
5
Insert the new water filter. Fill the
water tank with fresh drinking water
and attach the lid again. Insert the
water tank back into the machine.
Coffee and milk modules are
i
descaled using two separated pro-
cesses. When one of the descaling
processes is required, the screen
will inform you of the expected
delay until the other descaling
process is required.