Safety Warnings - Key Automation HALO Instructions And Warnings For Installation And Use

1 - SAFETY WARNINGS

ATTENTION !
ORIGINAL INSTRUCTIONS - important safety
instructions. Follow the instructions since
incorrect installation can lead to severe inquiry!
Save these instructions.
Read the instructions carefully before proceeding
with installation.
The design and manufacture of the devices
making up the product and the information in
this manual are compliant with current safety
standards. However, incorrect installation
or programming may cause serious injury
to those working on or using the system.
Compliance with the instructions provided
here when installing the product is therefore
extremely important.
If in any doubt regarding installation, do not proceed
and contact the Key Automation Technical Service
for clarifications.
Under European legislation, an automatic
door or gate system must comply with the
standards envisaged in the Directive 2006/42/
EC (Machinery Directive) and in particular
standards EN 12445; EN 12453; EN 12635
and EN 13241-1, which enable declaration
of presumed conformity of the automation
system.
Therefore, final connection of the automation
system to the electrical mains, system testing,
commissioning and routine maintenance must
be performed by skilled, qualified personnel, in
observance of the instructions in the "Testing and
commissioning the automation system" section.
The aforesaid personnel are also responsible for
the tests required to verify the solutions adopted
according to the risks present, and for ensuring
observance of all legal provisions, standards
and regulations, with particular reference to all
requirements of the EN 12445 standard which
establishes the test methods for testing door and
gate automation systems.
ATTENTION !
Before starting installation,
following checks and assessments:
ensure that every device used to set up the
automation system is suited to the intended system
overall. For this purpose, pay special attention to
the data provided in the "Technical specifications"
section. Do not proceed with installation if any one
of these devices is not suitable for its intended
purpose;
check that the devices purchased are sufficient to
guarantee system safety and functionality;
perform a risk assessment, including a list of the
essential safety requirements as envisaged in
Annex I of the Machinery Directive, specifying
the solutions adopted. The risk assessment is
one of the documents included in the automation
system's technical file. This must be compiled by a
professional installer.
Considering the risk situations that may
arise during installation phases and use of
the product, the automation system must
be installed in compliance with the following
safety precautions:
never make modifications to any part of the
automation system other than those specified
in this manual. Operations of this type can only
lead to malfunctions. The manufacturer declines
all liability for damage caused by unauthorised
modifications to products;
if the power cable is damaged, it must be replaced
by the manufacturer or its after-sales service, or in
all cases by a person with similar qualifications, to
prevent all risks;
do not allow parts of the automation system to
be immersed in water or other liquids. During
installation ensure that no liquids are able to enter
the various devices; should this occur, disconnect
the power supply immediately and contact a Key
Automation Service Centre. Use of the automation
system in these conditions may cause hazards;
never place automation system components near
to sources of heat or expose them to naked lights.
This may damage system components and cause
malfunctions, fire or hazards;
The drive shall be disconnected from its power
source during cleaning, maintenance and
when replacing parts. If the disconnect device
perform the
is not in a visible location, affix a notice stating:
"MAINTENANCE IN PROGRESS":
connect all devices to an electric power line
equipped with an earthing system;
ATTENTION !
EN
3