Zephyr AK2000 Use, Care And Installation Manual page 14

STEP 13
1. Reinstall electrical box cover.
STEP 15
1. Next, fasten the 3 front screws and begin tightening
all screws from rear to front.
STEP 17
1. Turn on electrical supply or plug into receptacles.
INSTALLATION
STEP 14
1. Reinstall bottom splash shield by first fastening 3
rear screws, (do not tighten all the way).
STEP 16
1. Connect duct to opening, inspect and tape all joints
with approved aluminum or duct tape.
STEP 18
1. On Cyclone & Whirlwind models, be sure to pull
both grease tubes over its opening.
12