Zephyr AK2000 Use, Care And Installation Manual page 13

11
STEP 7
1. Lift hood to bottom of cabinet
STEP 9 (also refer notes on pg. 16)
1. Fasten front of hood. Level all sides and adjust
accordingly.**
STEP 11
1. Pull electrical supply wire through drill out or use
#14 grounded wire for receptacles (not supplied)
INSTALLATION
STEP 8
1. Support hood to place, fasten both rear with screws
and washers provided.
STEP 10
1. Drill out cabinet base through electrical box with
3/4" boring bit.
STEP 12 (also refer notes pg. 16)
1. Connect both wires (blk) on hood to either power
supply (blk or wht). Ground green wire.**