KKT KOLBE EB8019EDP User Manual page 61

Cleaning and maintenance
Before starting the pyrolytic mode
• Remove accessories and cooking utensils, including
pull-out rails and protective elements, from the oven
before starting the pyrolytic mode and ensure that the-
re is no spilled food in the baking chamber to achieve
the best cleaning results.
• Remove large amounts of dirt from the cooking cham-
ber manually.
• Clean the inside of the appliance door and the edges of
the cooking chamber in the area of the seal.
Do not scrub or remove the seal.
• While doing these operations, make sure that the oven
switched off.
Setting pyrolytic self-cleaning mode
• Use the key and then the slider or
select the pyrolytic mode
• Make sure that there are no accessories or food in the
cooking chamber and close the door tightly.
• Press the key to start the pyrolytic mode.
At the start of operation, the control panel is automati-
cally deactivated and the oven door is locked until the
appliance has cooled down.
• Ventilate the room during pyrolysis operation.
Pausing and cancelling the pyrolytic mode
• When the pyrolytic mode is started, all other functions
of the appliance are automatically disabled.
• If you want to pause or cancel the pyrolytic mode, you
must first unlock the control panel.To do this, press
and hold the key for 3 seconds, then you can pause
or cancel the operation with the
pause, press twice to stop pyrolytic mode.
However, the appliance door is only unlocked automati-
cally when the temperature is safe.
Pyrolytic mode settings
• The pyrolytic mode settings are factory set and cannot
be changed.
After starting, the pyrolytic mode can only be paused or
stopped as described above.
After the pyrolysis process has been completed.
und to
.
key: Press once to
• When the pyrolytic mode is completed, a continuous
acoustic signal sounds. To interrupt this, press the
key or wait for the alarm to stop automatically.
• When the appliance has cooled down to a safe tempe-
rature, you can open the door again.
• When the cooking chamber has cooled down, remove
the combustion residue/ash by wiping the cooking
chamber including the door area with a damp cloth.
• Replace pull-out rails, protective elements and acces-
sories in the oven.
• If you wish to start another heating mode after pyroly-
sis, you must first release the automatic safety lock on
the control panel by pressing and holding the
for 3 seconds.
Notes:
• During pyrolytic mode, the frame on the inside of the
appliance may discolour. This is normal and has no
effect on the function.
The discoloration can be removed with a stainless steel
cleaner.
• Heavy soiling can cause white deposits to remain on
the enamel surfaces. These are caused by food resi-
dues and are harmless. They have no influence on the
functionality.
If necessary, you can remove the residues with lemon
juice or other cleaning agents.
key
61