Table of Contents
Advertisement
Power Supply Replacement
Tools required: Phillips head screwdriver
1. Follow "Preparation for Service" instructions before
proceeding.
2. Locate the power supply. (Figure 6)
3. Remove the screws that secure the holding bracket
and power supply to the unit.
4. Trace the wires to the main control board and discon-
nect.
5. Run the wiring from the new power supply to the main
control board.
6. Reinstall the bracket.
7. Ensure that all wires are replaced in the same manner
as prior to the service.
8. Reassemble in the reverse order as above.
Capacitive Controls and Display
Replacement
Tools required: Phillips head screwdriver
1. Follow "Preparation for Service" instructions before
proceeding.
2. In the upper right hand corner of the unit, above the
main control board, locate the controls and display
assembly and remove the 2 securing screws. (Figure 6)
1. Gently remove the assembly from the unit by pulling it
forward.
2. Disconnect the wire from the old assembly and install it
on the new assembly.
3. Reinstall the new board onto the unit.
4. Ensure that all wires are replaced in the same manner
as prior to the service.
5. Reassemble in the reverse order as above.
Figure 7
Media Tray screws (4)
14
Media LED Light Strips Replacement
Tools required: Phillips head screwdriver
1. Follow "Preparation for Service" instructions before
proceeding.
2. Remove the plastic media tray by removing the 4
screws: 2 on the left and 2 on the right of the tray.
(Figure 7)
3. Lift the plastic media tray out of the unit.
4. Remove the front panel by removing the 6 screws: 3 on
the left and 3 on the right of the tray.
5. Locate the LED assembly that needs to be removed.
6. Disconnect the wiring connections at either end.
7. Remove the assembly by pinching the plastic mounting
tabs with needle nose pliers and lifting off.
8. Install the new assembly onto the unit and secure the
LED strip to the unit.
9. Reattach the wire connections.
10. Ensure that all wires are replaced in the same manner
as prior to the service.
11. Reassemble in the reverse order as above.
Flame LED Strips Replacement
Tools required: Phillips head screwdriver
1. Follow "Preparation for Service" instructions before
proceeding.
2. Remove the plastic media tray by removing the 4
screws: 2 on the left and 2 on the right of the tray.
(Figure 7)
3. Lift the plastic media tray out of the unit.
4. Remove the front panel by removing the 6 screws: 3 on
the left and 3 on the right of the tray.
5. Remove the 17 screws along the top of the flame panel
and gently remove. (Figure 6)
6. Locate the LED strip that needs to be removed.
7. Disconnect the wiring connections at either end.
8. Remove the LED strip by pinching the plastic mounting
tabs with needle nose pliers and lifting off.
9. If lenses are not present on the new LED strip follow
the following two steps before proceeding to step 9.
(Figure 8.)
Front
I. Remove the lenses from the old LED strip (Figure 8.)
Panel
This will require some force when they are removed for
the first time. It may be helpful to use a flathead screw
driver to remove them,
II. Affix the lens to the new LED strip by aligning it over
the LED light and pressing down on it.
10. Install the new assembly and secure the LED strip to
the unit.
11. Reattach the wire connections.
Needle nose pliers
Wire cutters
www.dimplex.com
Advertisement
Table of Contents
