Additional Key Combinations - Dimplex Ignite XLF50 Service Manual

Hide thumbs Also See for Ignite XLF50:

Owner's manual (66 pages)

Table Of Contents

Table of Contents

rated wattage.

→ Activated and adjusted by repeatedly pressing the cor-

responding button on the remote.

• Indicated by the heater running at full heat, for a user set

amount of time, to quickly heat up a cold room/space.

The Heat Boost can be set for a maximum of 20 minutes,

in 5 minute increments.

Disable Heat

If desired, depending on the season, the heater on the unit

can be disabled. The function of the remaining controls will

continue to function as outlined in this manual.

Pressing the

and

time and holding for 2 seconds will disable and enable the

heater.

! NOTE: When the heater has been disabled and any of

the heat related functions are used, the Display will indi-

cate "---".

H .

Color Themes

Different presets of lighting color combinations are avail-

able in the unit.

→ Changed by repeatedly pressing the corresponding but-

ton on the remote or the unit.

• Cycles through the different preset light settings of the

unit, this includes different combinations of colors of the

flame base and media lighting.

! NOTE: Two of the themes in the cycle are a prism

where the unit cycles through a variety of colors. Press-

ing the

stops the cycling and holds the unit on the

preferred color, indicated by a solid circle. When the unit

is on prism, and is cycling through the colors, a rotating

circle will be displayed.

I .

Brightness

Changes the Brightness of the lights in the unit.

→ Adjusted by repeatedly pressing the corresponding but-

ton on the remote or the unit.

• Indicated by the second digit on the Display changing to

show: "H" (high), and "L" (low).

J .

Sleep Timer

The Sleep Timer can be set to automatically shut off the

fireplace after a preset time (from 30 minutes to 8 hours).

→ To set the timer press the timer button on the remote,

repeatedly, until the desired time is displayed.

• The Display will display the different times as it is ad-

justed. Once the timer has begun, pressing the

will display the time remaining before the unit turns Off.

! NOTE: The Sleep Timer can be cancelled at any time by

pressing the

button repeatedly until the sleep timer

displays nothing.

Resetting the Temperature Cutoff Switch

Should the heater overheat, an automatic cut out will turn

the whole unit off and it will not come back on without being

buttons on the unit at the same

Figure 2

reset. If the

displayed on the unit. It can be reset by turning the unit off

at the main disconnect panel and waiting 5 minutes before

turning the unit back on.

CAUTION: If you need to continuously reset the heater,

turn the unit off at the main disconnect panel and call

technical support at 1-888-346-7539.

Remote Control Battery Replacement

To replace the Battery:

1. Slide battery cover open on the remote control.

2. Correctly install one 3 Volt (CR2032 [longer life] or

CR2025) Battery in the battery holder.

3. Close the battery cover.

Battery must be recycled or disposed of properly.

Check with your Local Authority or Retailer for

recycling advice in your area