3.4
FPC の抜去について PULLING OUT FPC
6866 SERIES OPERATION MANUAL
106-03-004
③ 挿入した FPC が斜めになっていないか確認した上
回転軸方向に軽く荷重を加えつつアクチュエータ
中央部を押し下げ、ロックさせて下さい。
Make sure that the FPC is not inserted obliquely and
press down the center part of slider with soft
pressure applied in the direction of the rotation axis.
① アクチュエータ中央部を上方向に押し上げてください。
Lift up the center part of slider.
② FPC を少し持ち上げて引き抜いていてください。
Carefully pull up the FPC a little and then withdrew
it from the connector.
© 2022 KYOCERA Corporatio n
No. 205-03-289
PAGE 7/10