Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kyocera 6882 Series
Summary of Contents for Kyocera 6882 Series
- Page 1 取 扱 説 明 書 INSTRUCTION MANUAL 6882 Series 0.5mm-PITCH FPC Connector EDN19269 Nov. 1, 2019 S. Morita Y. Mamba Y. Fujii Rev. 発行者 確認者 承認者 EDN/DCN No 日付 Date Prepared by Checked by Approved by © 2019 KYOCERA Corporation 106-03-003...
-
Page 2: Table Of Contents
4. その他の注意事項 OTHER CAUTIONS ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ 8 4.1 フラックス上がりについて FOR FLUX WICKING ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ 8 4.2 エンボス梱包品の取扱いについて FOR HANDLING PRODUCTS PACKAGED IN TAPE & REEL ꞏꞏ 8 5. 製品の保管及び管理 STORAGE MANAGEMENT ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ 8 6882 SERIES INSTRUCTION MANUAL No. 205-03-6882-001 106-03-004 © 2019 KYOCERA Corporatio n... -
Page 3: 概要 Outline
0.5mm-pitch and 2.1mm-height for connecting an FPC and designed to meet the market requirements of downsizing in equipment and high-speed transmission system. Care should be taken when handling the connectors. This manual describes cautions in handling 6882 Series connectors. 2．各部の名称 NAME OF EACH PART <アクチュエータ開放状態 (納品時の状態)＞... -
Page 4: 取り扱い上の注意 Precautions In Handling
Consequently the actuator is should be opened when connector is in a reflow oven or when it is hand-soldered. After the connector is mounted, please avoid as much as possible to move the actuator without an FPC inserted. 6882 SERIES INSTRUCTION MANUAL No. 205-03-6882-001 106-03-004 © 2019 KYOCERA Corporatio n... -
Page 5: Fpc の挿入について Inserting An Fpc
Insert the FPC and push it until it hits the deepest part of the card slot of the connector. FPC はカードスロット底面に当てられるまで垂直に挿入して下さい。 Insert the FPC right straight to the slot end. 6882 SERIES INSTRUCTION MANUAL No. 205-03-6882-001 106-03-004 © 2019 KYOCERA Corporatio n... - Page 6 When closing the actuator, apply the force on the center of the actuator as shown below so that the stress could be applied evenly laterally. Do not apply the force to the side end. 6882 SERIES INSTRUCTION MANUAL No. 205-03-6882-001 106-03-004 ©...
-
Page 7: Fpc の抜去について Removing An Fpc
Good Good ※アクチュエータ開放角度は 60°までを目安とし、さらに開く方向への荷重を加えないようにしてください。 Caution: Actuator opening angle must be 60 degrees at maximum, and any further load shall not be applied in the opening direction. 6882 SERIES INSTRUCTION MANUAL No. 205-03-6882-001 106-03-004 © 2019 KYOCERA Corporatio n PAGE 6/8... -
Page 8: Fpc の屈曲について Flexion Of The Fpc
Please contact us when an FPC has to be bent repeatedly near the opening for FPC insertion. We will conduct evaluation tests according to conditions. 可能な限り長くしてください。 As long as possible ｺﾈｸﾀ Connector 6882 SERIES INSTRUCTION MANUAL No. 205-03-6882-001 106-03-004 © 2019 KYOCERA Corporatio n PAGE 7/8... -
Page 9: その他の注意事項 Other Cautions
Store connectors under normal temperature, normal humidity and no dust condition. When storing connectors out of the TAPE & REEL package (bare connectors), please do not apply pressure to contact tails. 6882 SERIES INSTRUCTION MANUAL No. 205-03-6882-001 106-03-004 © 2019 KYOCERA Corporatio n...
Need help?
Do you have a question about the 6882 Series and is the answer not in the manual?
Questions and answers