Table of Contents
Advertisement
5. SETUP INSTRUCTIONS
Refer to figure 4.0
1. Connect the fluid reservoir feed tube (1) to the valve inlet port (2).
2. Connect the valve airline (3) to the valve controller or other pneumatic device that is used to
control the valve.
3. Connect appropriate dispensing tip or nozzle to the fluid outlet port (4).
4. Set the valve controller pressure at 70 psi (4.8 bars)
5. Set the fluid reservoir pressure. Do not exceed 70 psi (4.8 bars)
6. Make sure all connections are tight
7. Place container under the valve outlet and activate the valve until the fluid flows steady.
The amount of fluid that flows through the valve is determined by:
• Valve open time
• Fluid reservoir pressure
• Dispensing tip size
1
2
4
Figure 4.0
6
3
Advertisement
Table of Contents
