Advertisement
10.
STANDARD ACCESSORIES
PART NUMBER
DESCRIPTION
TSD700-9
Oiler Cup, 90 Degrees
7305XCON
Cleaning Gel, 30cc Syringe
10.1 OPTIONAL ACCESSORIES
PART NUMBER
DESCRIPTION
TS918-46
4-Way Fluid Manifold
TN00DKIT
Complete Dispensing Tip Kit
9000-000-100
Sample Tip Kit
5322-SIT
Seal Insertion Tool
10.2 FLUID FITTINGS AND TUBING
PART NUMBER
DESCRIPTION
TSD1003-16
⅛'' NPT to ¼'' O.D. Tube, 90° Elbow
TSD1002-17
⅛'' NPT to ⅜'' O.D. Tube
TSD1002-18
⅛'' NPT to ¼'' O.D. Tube
TSD1002-38
¼'' NPT to ¼'' O.D. Tube
TSD1099-22
⅜'' O.D. X ¼'' I.D. Tube, Black, Polyethylene
TSD1099-23
⅜'' O.D. X ¼'' I.D. Tube, Clear, Polyethylene
TSD1099-24
¼'' O.D. X ⅛'' I.D. Tube, Clear, Polyethylene
TSD1099-25
¼'' O.D. X ⅛'' I.D. Tube, Black, Polyethylene
TSD1099-45
6mm O.D. X 4mm I.D, Clear, Polyethylene
TSD1099-46
6mm O.D. X 4mm I.D, Black, Polyethylene
TSD126-360BPK
Luer Lock Tubing, 60'' (1524mm) , Black
10.3 BRACKETS
PART NUMBER
DESCRIPTION
918-033-000
Productions Master Stand (Base & Support)
918-000-012
Rod Clamp Assembly
1212-000-008
6'' (152.4mm) Threaded Mounting Rod
12
5.
SET-UP INSTRUCTIONS
1. Connect the fluid reservoir feed tube (1) to the valve inlet port (2).
2. Connect the valve air hose (3) to the valve controller or other pneumatic device,
which is used to control the valve.
3. Connect an appropriate nozzle or dispensing tip (4) to the fluid outlet port.
4. Set the valve controller pressure at 70 psi (4.8bar).
5. Set the fluid reservoir pressure. Do not exceed 500 psi (34.5bar). For TS5322D,
do not exceed 100 psi (6.9bar).
6. Ensure all connections are tight.
7. Place container under the valve outlet and activate the valve until the fluid
flows steady.
The amount of fluid that flows through the valve is determined by:
•
Valve open time
•
Fluid reservoir pressure
•
Dispensing tip size
3
1
2
4
Figure 3.0
5
Advertisement
