Soundoff Signal UNIVERSAL UNDERCOVER ELUCTS010 Quick Installation Manual

UNIVERSAL UNDERCOVER™
LED INSERT - FORD INTERCEPTOR UTILITY ONLY
ELUCTS010(x) - 10-16 Vdc, 10' CABLE
KIT INCLUDES:
1 ea. - Assembled light head with Extreme Angle
Lens #1, in-line flasher and desired cable length
1 - Twist Lock Collar
2 - Gaskets
Undercover Light
Gasket 2x
Please see reverse for Technical
Specifications and Illustrations

Important Information:

• DO NOT cut the wires between in-line flasher and light head
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner's Manual for the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external strobe power supply.
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
1.800.338.7337 / www.soundoffsignal.com
1.
Twist Lock Collar
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to techservices@soundoffsigal.com.
S U P E R I O R C U S TO M E R R E L AT I O N S H I P S . S M A RT LY D E S I G N E D L I G H T I N G & E L E C T R O N I C S O L U T I O N S .
WIRE CONNECTIONS

WIRE HOOK-UP TABLE

WIRE COLOR: CONNECT TO:
RED +Vdc
BLACK Ground (-)
WHITE Pattern Select/Sync
Cruise Mode
GREEN
(+Vdc)
!
WARNING-HOT!
This product must be mounted with sufficient
clearance from any plastic parts. Failure to
do so may result in permanent damage to
the housing.

WARNING

!
This product contains high intensity LED
devices. To prevent eye damage, DO NOT
stare into the light beam at close range.
IMPORTANT INFORMATION:

MOUNTING INSTRUCTIONS

Up to 4 LED inserts can be synchronized
for alternating or simultaneous flash
patterns using the white (SYNC) wire.
See back for SYNC Configuration
instructions.
1. Remove the headlight assembly
according to manufacturer's
instructions.
2. Remove Green Plug from rear of
headlight assembly to get access to
pre-cut hole in the headlamp.
3. Snap the Universal Undercover LED
insert into the Twist Lock Collar as
shown on picture.
4. Install the Twist Lock Collar w/LED
assembly into the pre-cut hole in the
headlamp housing.
5. Use the supplied gaskets as shown
on left.
6. Complete wire connections and
test light prior to remounting vehicle
reflector assembly.
7. Complete wire connections and test
light prior to remounting vehicle
reflector assembly
8. Re-install reflector assembly
according to vehicle manufacturer's
instructions.
ELUCTS010(x) 3.13