TMC424_UGE_466A
1/22/08
Toro TMR-1 Handheld Remote Installation (Optional)
The TMC-424E is equipped for operation with the Toro TMR-1 handheld remote
control. A handheld control option is provided in Special Functions that
enables/disables handheld operation. By default operation is enabled. Refer
to page 13 to disable handheld remote operation.
1. Install the TMR-1 remote receiver plug assembly according to the user's
guide provided with the TMR-1 kit.
2. Route the receiver power wires and control cable into the cabinet through
one of the available knock-out access holes.
3. Connect either power wire to the Hot Post terminal, and the remaining
power wire to a station common (C) terminal.
4. Plug the RJ-11 connector into the Handheld Remote Port receptacle.
5. For complete handheld remote operating information, refer to the user's
guide provided with the TMR-1 kit.
5:00 PM
Page 27
TMR-1
Receiver
Receiver
Plug
27