Controller Programming; Set Current Time And Date; Select The Program; Set Station Run Time - Toro TMC-424E User Manual

TMC424_UGE_466A 1/22/08

Controller Programming

N O T E : English display prompts and 12-hour (a.m./p.m.) time format are factory-
default settings. To select an optional display language, including Spanish, French,
Italian, German and Portuguese, and/or a 24-hour time format, refer to the Special
Function setup procedures on page 13.

Set Current Time and Date

1. Turn the Function Dial clockwise to Current Ti m e / D a y
begin flashing.
2. Adjust the display by pressing the
NOTE: Hold either button down for rapid advance.
3. Press the
4. Repeat steps 2 and 3 to set the current minutes, year, month and day
(current weekday will be set based on calendar setting).
5. Return the Function Dial to RUN

Select the Program

N O T E : If the controller has been previously programmed, the user-defined
program settings can be quickly erased and reset to factory defaults. See "Using
the Program Memory Erase Feature" on page 13.
To simplify the programming process, the following procedures are provided to
define the operating parameters of one program at a time.
To begin, set the program switch to select program A, B, C, or D.

Set Station Run Time

A station is assigned to the selected program when it is given a run time
duration. The station can have only one run time assignment per program, but
can have a separate run time assignment in each program. By default, station
run time is defined in minutes and hours. To enable station run time to include
seconds, see "Station Runtime Display Format" on page 13.
1. Turn the Function Dial to Station Ti m e s
2. Press the
station output terminal will be shown on the display as a solid circle.
3. Press the
to 1 minute – 8 hours (in 1-minute increments). If seconds format is enabled,
station run time can be set from 01–60 seconds.
NOTE: Hold either button down for rapid advance.
4. Repeat steps 2 and 3 for all stations to be assigned to the selected program.
6
5:00 PM Page 6
button to select the next field.
or button to select the station number. The corresponding
or buttons to adjust the station run time from Off (-- -- --)
or buttons.
when finished.
.
. The hour digits will