Precautions For Installation - Pro-face GP4100 Series Quick Manual

Compact graphic operator interface

Precautions for Installation

Use an installation fastener to install a GP4100 unit on a operation panel and make wire connections for power and

communication cables.

(Caution: To prevent electric shock, please make sure the power is not supplied while the above installations are made.)

Fastener Insertion Slot

Power Connector

COM I/F Connector *

* RS-232C and RS-422/485 Types(GP-4105, and GP-4106)

Precaution for Fastener

Precaution for Power Connection

Precaution for Communication Cable Connection

RS-232C and RS-422/485 Types (GP-4105, and GP-4106)

RS-485 (isolation) Type (GP-4107)

USB Type A

USB mini B

Fastener Insertion Slot

- Panel thickness acceptable: 1.0mm - 5.0mm [0.04 – 0.20in]

- A power connector is not removable from a GP unit.

Do not unnecessarily pull or jiggle the connector.

It could damage the power connector.

- PLC connection cable for each supported PLC is available

as accessory (see page 15).

Please refer to the Device/PLC Connection Manual for the

connections with other PLCs. Make sure that the connector

is not connected with a GP unit while the connector wiring

is made. Otherwise, it could lead electric shock.

The connector is D-Sub9 (socket).

Regarding the pin connection, please refer to the GP-4100

Series Hardware Manual.

GP4100 Series Quick Guide

USB Front

Cable (sold

separately)

Table of Contents