Display Error Messages - Pro-face GP4100 Series Quick Manual

Display Error Messages (1)

Specify alarm settings to display error messages shown by changes of bit address or data in a connected device.
How to Set Alarms: Register a corresponding message to each bit address
When the address M0000 is ON, display "Press the emergency stop button."
When the address M0000 is ON, display "Press the emergency stop button."
When the address M0001 is ON, display "Oil pressure overload."
When the address M0001 is ON, display "Oil pressure overload."
When the address M0002 is ON, display "Exceed the maximum pressure."
When the address M0002 is ON, display "Exceed the maximum pressure."
When the address M0003 is ON, display "Foreign material is detected. Remove it immediately."
When the address M0003 is ON, display "Foreign material is detected. Remove it immediately."
A long message can be displayed on screen as a banner
A long message can be displayed on screen as a banner
message scrolled at the bottom of the screen.
message scrolled at the bottom of the screen.
エラーコード一覧 エラーコード一覧
エラーコード一覧
Error Code List
6B4D
3A7E
GP4100 Series Quick Guide
1. Show the alarm setting screen
Click the icon to show the alarm setting screen.
2. Specify a backup history
If [Backup History] is checked, alarm records remain saved
even after a GP4100 Series unit is turned OFF.
3. Specify settings for an alarm
Register bit addresses, trigger conditions and messages.
The registered alarm information can be grouped into up to 8
blocks by setting addresses and messages in each block.
If [Word Monitoring] is selected, messages are registered
If [Word Monitoring] is selected, messages are registered
to be shown on screen in accordance with changes of data
to be shown on screen in accordance with changes of data
values in a connected device.
values in a connected device.
If [Bit Monitoring] is selected, messages are registered to
If [Bit Monitoring] is selected, messages are registered to
be shown on screen in accordance with changes of
be shown on screen in accordance with changes of
corresponding bit addresses.
corresponding bit addresses.
* Other than using the icon, alarm settings can be made from the [Common Settings] menu.
9
Confirm the error
to see a message