Advertisement
3. filter hood: a) Remove tape covering the 3×6-mm screw on the holding arm (see arrow).
b) The screw protrudes about 3 mm. This allows it to be pushed into the U-shaped slot (a). Push the
holding arm in as far as you can, even if it takes a little force. Then tighten the screw until it is flush.
4. holding arms: a) Depending on whether you need one or both holding arms for suction, attach one
or both.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 91934
Page 8
04 2023-1
Advertisement
