Table of Contents
Advertisement
Quick Links
Operation Manual
Wet and Dry Vacuum Cleaner
63113
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Related Manuals for WilTec XPOtool 63113
Summary of Contents for WilTec XPOtool 63113
- Page 1 Operation Manual Wet and Dry Vacuum Cleaner 63113 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Introduction Thank you for purchasing this quality product. To minimize the risk of injury we urge that our clients take some basic safety precautions when using this device. Please read the operation instruc- tions carefully and make sure you have understood its content. Keep these operation instructions safe.
- Page 4 Important safety instructions • A defective power cable must be replaced by a qualified electrician. • The device must not be used by persons (including children) with limited physical, sensory or mental capabilities or a lack of experience and knowledge, unless they are supervised or have been instructed by a person responsible for their safety about the correct use of the device.
-
Page 5: Operation
Operation Before starting the device, make sure that the dust filter is in place. Unwind the power cord completely. Plug in the plug and switch on the device. After use, pull the plug out again. Set the switch to “I” to use the vacuum cleaner as a wet or dry vacuum cleaner. Set the switch to “II”... -
Page 6: Troubleshooting
Cleaning and maintaining Open the dust container. Remove the dust filter. Empty the container. Wash the dust filter with clean water. Let the dust filter dry. Re-assemble the vacuum cleaner. Troubleshooting Problem Possible cause Solution Motor does not start. Cable not firmly plugged in Firmly plug in cable. -
Page 7: Technical Specifications
Technical specifications Rated voltage (V) 2230 AC Rated frequency (㎐) Power (W) 1200 Operation pressure (kPa) ≥16 (0.16 bar) Rage (m) Scope of delivery • 1 × pond vacuum cleaner • 1 × suction tube (4 pieces) • 1 × drain hose •... - Page 8 This logo indicates that this electric equipment must not be disposed with the domestic waste. The company WilTec Technik GmbH has been registered in the German registry EAR under the WEEE- registration number DE45283704. Disposal of used electrical and electronic appliances...