Troubleshooting - Server CP-200 Manual

TROUBLESHOOTING

PROBLEMS WITH FLOW OR PORTIONS?
• Clean pump.
• Food product may be too thick or contain
a solid that will not pass through pump.
• If used: Ensure gaging collar(s) are undamaged
and properly installed on head tube.
PLUNGER DOESN'T
RETURN TO TOP
AFTER DISPENSING?
• Ensure that the spring is functional.
Replace broken spring if necessary.
• Ensure that the washer is installed
between the spring and piston head.
FOOD PRODUCT OOZES OUT
AROUND LOCKING COLLAR?
• Ensure seal is properly installed on piston.
TIP: Seal has a slight taper.
Install with flat side towards
top, flared side down.
PUMP DRIPS?
• Clean discharge tube with supplied brush.
• Inspect all o-rings. Replace if damaged.
• Food product may be too thin.
Visit www.Server-Products.com for more tips.
SERVER PRODUCTS
LIMITED WARRANTY
This Server product is backed by a two-year
limited warranty against defects in materials and
workmanship. See Server-Products.com
NEED HELP?
Server Products Inc.
3601 Pleasant Hill Road
Richfield, WI 53076 USA
Chat with us!
spsales@server-products.com
262.628.5600 | 800.558.8722
Page 8
GENERAL SERVICE,
REPAIR OR RETURNS
Before sending any item to Server Products for
service, repair, or return, contact Server Products
customer service to request a Return Authorization
Number. Merchandise must be sent to Server
Products with this number. Service is extremely
prompt. Typically, units are repaired and ship out
within 48 hours of receipt.
Merchandise being returned for credit must be in
for details.
new and unused condition and not more than 90
days old and will be subject to a 20% restocking
charge.
Please be prepared with your Model, P/N and
Series located on the lid or base of the unit.
MODEL
Example:
XXXX
P/N
#####
Manual 01588-RevF 012422
SERIES
##X ##X