Proline PROCD8B Manual page 86

IMPORTANT: The water discharge hose must be installed at a height of 80 cm
maximum.
IMPORTANT: The water discharge hose must not be bent, folded or stepped
over.
Adjusting the Feet
• For the dryer to work with less noise and vibration, it must be stable and
balanced on its feet. Adjust the feet to ensure that the dryer is balanced.
• Rotate the feet to the right and to the left until the dryer is even and stable.
IMPORTANT: Never remove the adjustable feet.
Electrical Connection
ATTENTION:
• Your dryer is set to 220-240 V and 50 Hz.
• The mains cable of the dryer is equipped with a special plug. This plug
must be connected to an earthed socket protected by a fuse of 16 Amperes
as indicated on the type plate. The fuse current rating of the power line
where the outlet is connected must also be 16 amperes. Consult a qualified
electrician if you do not have such an outlet or fuse.
• The manufacturer cannot be held responsible for damages resulting from
usage without earthing.
IMPORTANT: Operating your dryer at low voltage values will shorten the service
life and decrease the performance of your dryer.
Under Counter Installation
• Leave at least 3 cm of space between the side and rear walls of the dryer and
the underside of the worktop when installing your dryer under a counter.
• Assembly / disassembly under the counter if neccessary must be done by
authorized service.
PROCD8B IB.indd 83 PROCD8B IB.indd 83
There is risk of fire and electric shock.
83
27/7/2022 9:41 AM 27/7/2022 9:41 AM