Advertisement
Quick Links
Advertisement
Related Manuals for LevelOne EHU-0500T
Summary of Contents for LevelOne EHU-0500T
- Page 1 10Mbps E THERNET SER’S ANUAL...
-
Page 2: 10Mbps Ethernet Hub
10Mbps Ethernet H USER’S MANUAL Trademarks: All product and brand names are trademarks and/or registered trademarks of their respective companies. -
Page 3: Table Of Contents
Table of Contents Federal Communications Commission Statement Chapter 1. INTRODUCTION.........1 This equipment generates, uses and radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. This equipment 10Mbps Ethernet hub..........1 has been tested and found to comply with the limits for a Class A Product Features.......... -
Page 4: Product Features
INTRODUCTION Media EHU-0500T EHU-0501TB EHU-0900TB 10Base-T/STP Congratulations on your purchase of a Ethernet hub. Your hub was 10Base-2/BNC designed and manufactured to give you years of trouble-free and Uplink port reliable service. LED indicators Power/PWR The hub is designed for plug-and-play installation and easy Collision/COL management. - Page 5 Uplink DC IN Media 17 port 10Base-T/STP (The Rear Panel of EHU-0500T) 10Base-2/BNC Uplink port LED indicators LINK ? ACT - Power/PWR (The Front Panel of EHU-0500T) Collision/COL BNC Partition Uplink DC IN LINK Activity/ACT Power Supply (The Rear Panel of EHU-0501TB)
- Page 6 Power/PWR: Lit whenever the hub is connected to a power source and is turned on. Uplink TP16 TP15 TP14 TP13 TP12 TP11 TP10 TP 1 DC IN (The Rear Panel of EHU-1700TB) Collision/COL: Lit whenever a packet collision occurs on the Ethernet network.
-
Page 7: Chapter 2. Installation
INSTALLATION The Ethernet Hub makes your various types of Ethernet networks TWISTED PAIR CABLE interconnection comes true. Using the hub, you can efficiently build up and flexibly interconnect twisted-pair Ethernet networks. You may use Cat. 3 or better cables for your 10Base-T Ethernet Furthermore, having great expansion capability, the hub keeps your environment. - Page 8 The hub should be located in a secure place accessible only to the I. Network Interconnection via Twisted-Pair Wire: network administrator. It should be close to a power source, since it requires power in order to operate. 100M 100M When a suitable location is identified, connect one end of the power 100M to the hub and plug the other end into the power outlet.
- Page 9 Note: If the BNC port on the hub is not used, a 50 ohm terminator must be attached on it. Cascading the hubs by Uplink port When connecting two hubs, one hub is used UpLink port and the other end is on the normal port of hub. The UpLink port connect directly to a normal Twisted Pair cable, and the crossover cable is not needed.