Table of Contents
Advertisement
ON-GROUND INSTALLATION WITH MULTISWITCH ON BACK OF DISH - OPTION #1
1. To install the outdoor multiswitch to the back of the antenna, use the #8 self tapping screws and washers
provided in the multiswitch carton. CAUTION: Use a hand tool to tighten the screws until the face of the screw head is
evenly touching the multiswitch mounting lug – then tighten
nections between the multiswitch and the LNBs. A set of gray cables is provided for Option #1, in most antenna models.
The cables are routed from the multiswitch through the feed tube to the LNBs as shown in Figure 10. The cables should
be dressed as shown using the cable clips provided in the hardware bag. IRD cables should be routed underneath the
gray cable set as illustrated in Figure 9 (one IRD cable shown in black). With the exception of the IRD cable, it may be
easier to perform much of this installation on the ground.
turn more. You will also need 4 cables to make the con-
FIGURE 9
-12-
Advertisement
Table of Contents
