Test Armrest Control Switch; Tighten Brackets; Set Upper And Lower Travel Limits - Harmar Mobility PINNACLE SL300 Series Installation & Service Manual

PINNACLE STAIRLIFT: SECTION 4
INSTALLATION
6. Making sure that the remote is pointed at one
of the IR sensors on the chassis, press and
release the "Up" or "Down" button of the first
remote. The first remote is now programmed.
7. Press and release the "Up" or "Down" button
on the second remote. The second remote is
now programmed.
8. Upon completion, two beeps will indicate
that both remotes have been successfully
programmed.
9. Turn the "On/Off" switch to the "Off"
position.
10. Connect the 6-pin and 8-pin chair wire
harness to the chassis and then turn the red
"On/Off" switch back to the "On" position.
11. Test each remote in both the up and down
directions.
TEST ARMREST CONTROL
SWITCH
1. Ensure that the stairlift travels correctly by
operating the armrest control switch while
standing in front of it.
2. Press the switch in the upstairs direction
to move up. The lift will begin to smoothly
accelerate upward. The lift will continue to
move upward as long as the switch is pressed.
3. Release the switch and the lift will come to an
immediate stop.
4. Press the switch in the downstairs direction
to move downward. The lift will begin to
smoothly accelerate downwards.
5. Release the switch and the lift will come to an
immediate stop.
6. Run the lift all the way up and down the rail
to ensure that the top of the seat back has at
least a 1/2" in clearance from the wall and any
obstructions.
SL300 PINNACLE STAIRLIFT:
16
26MAY2022 | 630-00100 H

TIGHTEN BRACKETS

Install and fully tighten the rail bracket mounting
screws (four (4) screws per bracket). For hardwood
stairs, a pilot hole should be drilled first. For
plywood or particle board stairs, care must be
taken to prevent stripping.
SET UPPER AND LOWER
TRAVEL LIMITS
Install Manual
WARNING
!
Do not ride on the chassis or lift until the
installation is complete.
1. Test the lower travel limit by operating the lift
downward, keeping the switch pressed. The
unit should begin to decelerate about 3" from
its final resting position and stop clear of the
floor.
2. The final stopped position can be adjusted
to accommodate the height of the user by
repositioning the limit cam located in a slot in
the rail.
3. Use a 5/64" Allen wrench to loosen the set
screw in the limit cam. Adjust the limit cam
up or down and re-tighten the set screws.
Repeat the above steps until the lift stops in
the desired position.
4. Repeat the above steps to set the upper limits.
For safety, the footrest should be set at least
level with the upper landing.
5. The optimum position is met when the seat
height above the floor is the same at the top
and bottom of the stairs.