Volvo 240 1991 Owner's Manual page 127

Volvo 1991 240 Model
cleaned and properly tightened.
5 If any electrical welding work is performed on the vehicle, the ground lead and all the connecting
cables of the alternator must be disconnected and the welder wires placed as near the welding point as
possible.
Jump starting
CAUTION: Improper hook-up of jumper cables or the use of other than 12 volt batteries could result
in damage to equipment and/or battery.
Check that cars are not touching to prevent premature completion of negative circuit.
Note the position of the battery terminals. When using jumper cables, first connect booster battery
positive (+) terminal to car battery positive (+) terminal. Then connect booster battery negative (-)
terminal to a stationary solid metal part on the engine at a point away from the battery. Do not connect
booster cable to any part of fuel system or any moving parts. Avoid touching hot manifolds.
WARNING!
To prevent possible explosion, never expose battery to open flame or electric spark. Do not smoke
near battery. Batteries generate hydrogen gas which is flammable and explosive.
Battery fluid contains sulfuric acid which can cause serious injury.
Do not allow battery acid to contact eyes, skin, fabrics or painted surfaces. If contact occurs,
thoroughly flush affected area immediately with water.
Obtain medical attention immediately if eyes are affected.
After engine has started first remove negative (-) jumper cable, then positive (+) terminal jumper cable.
file:///K|/ownersdocs/1991/1991_240/91240_16.htm (9 of 10)12/30/2006 8:57:17 AM