Turning On The Product; Turning Off The Product; Control Panel / Remote Control; Selecting An Operating Mode - Silvercrest SHLF 2000 D2 Operation And Safety Notes

˜ Turning on the product
Connect the power plug
socket-outlet .
Activating the standby mode: Set the on/off
18 ] [
to I . A short beep sounds . The
switch
[ 6 ]
display shows the room temperature
and the timer indicator
Turning on the product: Press
product switches to fan mode .
NOTE: When the product is in operation, the
[ 11 ]
control lamp is lit .
˜ Turning off the product
Switching to standby mode: Press
NOTE: The fan continues to run for about
another 4 to 5 seconds . Afterwards, the
product turns off and the control lamp
out .
Turning off the product fully: Set the on/off
18 ] [ to 0 .
switch
˜ Control panel / Remote control
Press the buttons on the control panel
use the remote control
NOTE: In standby mode, no settings can be
made . First, switch on the product by pressing
8 ] [ [ 23 ]
.
Button Setting
3 ] [ [ 22 ]
Timer
[ 4 ] [ 25 ]
Swivel function
[ 5 ] 24 ] [
Operating mode
7 ] [ 27 ] [
Increase value
8 ] [ [ 23 ]
Standby/operation
[ 9 ] 26 ] [
Decrease value
14 GB/CY
19 ] [
to a suitable
31 ] [
30 ] [ 0:00 flashes .
[ 8 ] 23 ] [
. The
8 ] [ 23 ] [
.
[ 11 ]
goes
[ 1 ]
or
[ 20 ]
to make settings:
˜ Selecting an operating mode
Switching the mode: Repeatedly press
[ 5 ] [ 24 ]
until the desired operating mode
[ 29 ]
indicator is shown in the display
Display Operating mode
Fan
In fan mode, no heating level is
activated .
Half heating level
50 % heating power
Full heating level
100 % heating power
Automatic heating level
The product automatically adjusts
the heating level to the ambient
temperature .
Frost protection
At room temperature under
+6 °C, the product turns on
automatically .
The product heats the room
until the temperature exceeds
+12 °C .
At a temperature of +12 °C, the
product turns off automatically .
NOTES:
Whether heating level
appropriate selection, depends on the room
size . We recommend first operating the
product on heating level
level if the heat output on heating level
not sufficient .
The operation mode is memorized when the
product is switched to standby mode . When
the product is switched on again, the previous
operation mode will be recalled .
6 ] [
:
or is the
. . Switch to heating
is