Regulatory Information; Specifications - Mitsubishi PAC-SDW01RC-1 Installation Manual

Regulatory Information

FCC Compliance Statement (Part 15.19) (USA Only)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that may cause undesired
operation
FCC Warning (Part 15.21) (USA Only)
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
FCC Interference Statement (Part 15.105 (b)) (USA Only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and receiver
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV
technician for help
SDW01 Installation Manual

Specifications

Table of Contents
Operating Ambient Temperature
• SDW01 controller/wall plate/adapter:
14 to 120 °F (-10 to 50 °C)
Operating Relative Humidity
• SDW01 controller/wall plate/adapter:
5% to 90% (non-condensing)
Physical Dimensions (Height, Width, Depth)
• SDW01 controller + wall plate:
3-3/8" x 3-3/8" x 1" (86 mm x 86 mm x 23 mm)
• SDW01 adapter:
3" x 1-8/10" x 5/8" (74 mm x 46 mm x 16 mm)
©2023 Mitsubishi Electric Trane HVAC LLC.
Suwanee, GA 30024
47007-0013910 Rev A
Printed in China
SDW01 Installation Manual 11