Table of Contents
Advertisement
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
13.1 Malfunctions
Fault
The appliance is not
working.
Home Connect is not
working properly.
After the appliance
has been switched
off, the illuminated
ring flashes white
slowly three times.
After the appliance
has been switched
off, the illuminated
ring flashes white
rapidly six times.
The fan continues to
run after the appli-
ance has been
switched off. The illu-
minated ring flashes
slowly orange.
The appliance
switches off while op-
erating. The illumin-
ated ring is flashing
orange and white al-
ternately.
Cause and troubleshooting
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
No connection to the remote fan unit.
Check whether the plugs on the connection cable for the remote fan unit are properly in-
▶
serted.
Different causes are possible.
Reset the saved connections to the home network and to Home Connect.
▶
Go to www.home-connect.com.
▶
The grease filters are saturated.
Clean the grease filter in the dishwasher. → Page 18
▶
Clean the grease filter by hand. → Page 17
▶
The odour filter in the remote fan unit is saturated.
Change the odour filter in the remote fan unit. → Page 18
▶
The fan run-on is switched on.
Observe the information about the fan run-on → Page 8.
▶
Safety shut-off: No actions have been performed for an extended period.
Ensure that there is a connection to the remote fan unit.
1.
Turn the control knob to .
2.
Switch the appliance back on.
3.
If the illuminated ring flashes again after you have switched the appliance back on, con-
4.
tact customer service.
The appliance remains off after a power cut.
Ensure that there is a connection to the remote fan unit.
1.
Turn the control knob to .
2.
Switch the appliance back on.
3.
If the illuminated ring flashes again after you have switched the appliance back on, con-
4.
tact customer service.
The window is closed using the window contact switch.
Open the window.
1.
Turn the control knob to .
2.
Switch the appliance back on.
3.
If the illuminated ring flashes again after you have switched the appliance back on, con-
4.
tact customer service.
Troubleshooting en
19
Advertisement
Table of Contents
