General Inspection - Velotric Thunder 1ST Manual

General Inspection

Handlebar
■ Ensure that the handlebar is at 90° to the front wheel. For more detailed information, refer to
"Adjust the Handlebar Angle" .
90°
■ Ensure that the handlebar is tightened sufficiently so that it will not twist out of alignment and
does not rotate in the stem.
■ Ensure that no cables are pulled or caught when you turn the handlebar from side to side.
■ Ensure that the handlebar and stem are aligned, correctly adjusted, tightened, and allow proper
steering.
Front Fork
■ Ensure that the front fork is not bent or broken.
■ Ensure that the front fork is securely tightened.
Wheels and Tires
■ Ensure that tires are holding air and
inflated to the recommended PSI indicated
on the tire sidewall. Do not overinflate or
underinflate tires.
The standard tire pressure on a Velotric
Thunder 1 ST is 75 PSI, as shown in the
illustration on the right.
■ Ensure tires have good tread, have no
bulges or excessive wear, and are free
from any other damage.
■ Ensure rims run true and have no obvious
wobbles, dents, or kinks.
■ Check each wheel spoke. If any are loose
or broken, seek help from a qualified
mechanic.
12
90°
■ Check the axle nuts on the rear wheel to ensure they are correctly tightened.
■ Check the security of the front and rear wheel mounting. The wheel security and hardware
torque should also be checked on a regular basis. For more detailed information, refer to
"Recommended Torque Values" .
Saddle and Seatpost
■ Ensure that the saddle is in line with the center of the frame.
90°
■ Check that the seatpost is tightened sufficiently so that the saddle will not twist out of
alignment, or move or tilt up and down.
■ Ensure that the seatpost is fully inserted over the minimum insertion mark.
Chain
■ Ensure that the chain has the correct
tension and won't fall off the chainring
during a ride. If you are unsure about the
correct tension, seek help from a qualified
mechanic.
■ Ensure that the chain has no kinks, rust,
broken pins, plates, or rollers.
■ Pay special attention if you live in a coastal
or dusty area. Ensure that the drivetrain is
clean and lubricated with lubricating oil.
Pedals
■ Ensure that the pedals are securely tightened to the cranks.
■ Ensure that the pedals are parallel to the ground and can rotate freely when the ebike is centered.
■ Ensure that the pedals and your shoes are clean and free of debris that could affect your grip
or interfere with the pedal system.
90°
13