Recommended Torque Values; Adjusting For Comfort And Safety - Velotric Thunder 1ST Manual

Recommended Torque Values

Always tighten the fasteners to the correct torque. Too much torque can stretch, deform, or break
a fastener or the part it attaches to or tightens. Too little torque can allow the part to move and
may lead to fatigue and breakage of the fastener or the attached part. Either mistake can lead to a
sudden failure of the fastener, causing you to lose control and fall.
Category Fastener
Handlebar Grip clamp bolts
section
Stem clamp bolts
Shifter clamp bolt
Brake lever clamp bolts
Stem faceplate bolts
Stem top cap bolt
Brake Disc brake bolt
Disc brake adapter bolt
Brake rotor clamp bolts
Saddle Seatpost clamp bolt
Saddle adjustment bolts
Frame Control panel mounting bolt
Rear derailleur mounting bolt
Derailleur cable clamp nut
Motor axle nuts
Kickstand mounting bolts
16
Tool Torque Spec. (Nm)
M3 Allen key 2-4
M5 Allen key 13-14
M5 Allen key 8-12
M4 Allen key 7-9
M4 Allen key 6-8
M4 Allen key 7-9
M5 Allen key 7-10
M5 Allen key 7-10
T25 screw wrench 5-7
M5 Allen key 7-9
M6 Allen key 12-14
M2 Allen key 2-4
M5 Allen key 8-11
M5 Allen key 4-7
18mm wrench 40-50
M5 Allen key 8-12
ADJUSTING FOR
COMFORT AND SAFETY
Adjust the Saddle Height
Adjust the Saddle Angle and Horizontal Position
Adjust the Brake Lever Positioning
Adjust the Stem Angle
18
20
21
22