Concord Camera Eye-Q 5330z User Manual page 153

Problem Check
Is the power of the camera
turned off?
Are the batteries exhausted?
Are the batteries inserted with the
The image
correct polarity?
cannot be
played
Is the CF card is inserted in the
back on
camera? ( Is "NO CARD" dis-
the LCD
played on the LCD monitor? )
monitor.
The auto power off function acti-
vates.
Is the focus lamp ( green )
blinks slowly (about 2 times in
a second ) and "PLAY BACK"
blinks on the LCD monitor?
Theimage
Did you take a picture within
recorded in
the flash range?
the flash
mode is
dark.
Solution
Rotate the function dial to
switch to turn on the camera.
Replace all four batteries or use the AC adapter
( sold separately ).
Remove the batteries and then insert the batteries by
following the +/- diagram indicated in front of the bat-
tery-chamber door.
When "NO CARD" is displayed on the LCD monitor and
"CF" is displayed on the data panel, the CF card is not
set. Insert the CF card.
Slide the power switch to turn on the camera again.
The camera reads out the image data from the CF
card.
Wait until the reading is completed and the focus lamp
and "PLAY BACK" stop blinking.
Take a picture within the flash range ( 0.4 to 3 m ) .
and slide the power
Page
80
25
28
25
25
29
44
153