Presser Foot Height; Darning Foot Height - Bernina activa 125 Service Manual

Presser foot height

Standard:
Lower the feed-dog.
•
Raise the lifter lever.
•
Check the height with 7.5 mm gauge 86.
•
Correction:
Loosen screw 64 on the presser foot bar guide.
•
Place the presser foot on the gauge (7.5 mm). Keeping
•
it parallel to the markings.
Press the presser foot bar down by hand.
•
Tighten screw 64.
•

Darning foot height

Standard:
Attach the darning foot.
•
Lower the feed-dog.
•
Turn the handwheel until the presser foot bar has rea-
•
ched its lowest position.
Use the gauge 87 (0.5 mm) to check the distance bet-
•
ween the needle plate and darning foot sole.
Correction:
Loosen screw 88 on the hopper mechanism lever.
•
Place darning foot on the gauge 87.
•
Tighten screw 88 (note position in regards to the cam).
•
87
86
0,5 mm
35
64
88