Crestron FlipTop FT2 Series Quick Start Manual page 6

FT2-700-MECH-PTL
FlipTop™ FT2 Series Cable Management System, 700 Size, Mechanical, Pass-Through Lid
Install the Blank and Keystone Plate Module
Blank plate modules (sold separately) fill empty slots in module rows,
and keystone plate modules (sold separately) allow for cables
terminated with standard keystone jacks to be installed in the FT2
assembly. The blank and keystone modules each require one empty
module slot for installation.
To install a blank or keystone plate module into the
FT2-700-MECH-PTL:
Slide the blank plate module down into the appropriate module slot.
l
Use the guide ribs on the front and rear of each module to help
position it in the FT2 assembly.
For the keystone plate module, complete the following steps.
l
1. Snap the cable's keystone jack into the keystone opening in the
keystone plate module.
2. Feed the cable down through the empty module slot.
3. Slide the attached keystone plate module down into the same
module slot using the front and rear guide ribs to assist with
positioning.
Install the Locking Bars
To install the locking bars:
1. Position the locking bars so that the gasket and screws attached to
the locking bars engage the screw holes in the FT2 assembly.
2. Use a screwdriver to secure the locking bar screws to the FT2
assembly.
CAUTION: Do not overtighten the locking bar screws.
Quick Start
6