Install The Modules - Crestron FlipTop FT2 Series Quick Start Manual

FT2-700-MECH-PTL
FlipTop™ FT2 Series Cable Management System, 700 Size, Mechanical, Pass-Through Lid
Secure the FlipTop Assembly
To secure the FT2-700-MECH-PTL to the table surface:
1. Gently remove the bezel before securing the FT2 assembly to the
table. It is held in place with magnets.
2. Ensure that all four swiveling dogs are tucked inside of the FT2
assembly, and then insert the FT2 assembly into the mounting hole
until the top lip is flush with the table surface.
3. Carefully tighten the four swiveling dogs in each corner of the FlipTop
assembly clockwise until the FT2 assembly is secured in place against
the table. Do not overtighten the swiveling dogs.
CAUTION: A screwdriver or manual torque screwdriver at its lowest
setting may be used to tighten the swiveling dogs. Avoid stripping
the swiveling dogs and damaging the table.
If removing the FT2-700-MECH-PTL from the table, ensure that
the screwdriver rotation is set correctly before loosening the
swiveling dogs.

Install the Modules

All modules are sold separately and not included with the
FT2-700-MECH-PTL FlipTop assembly. Installation procedures for most
modules are available in separate product documentation. For more
information, refer to the specific product manual located at
www.crestron.com/manuals.
The following sections provide best practices and installation procedures
for pass-through cable modules and blank plate modules.
Module Best Practices
Follow the best practices below when performing module installation.
Perform module installation in the following order:
l
1. AC Power Outlet Modules (FT2A-PWR-US, FT2A-PWR-EU,
FT2A-PWR-AU, FT2A-PWR-FR, FT2A-PWR-IS, FT2A-PWR-IT,
FT2A-PWR-SW, FT2A-PWR-UK, and FT2A-PWR-UN)
2. Retractor modules (FT2A-CBLR-GR
3. All other modules (FT2A-CP
FT2A-PLT-PT, and FT2A-PLT-BLANK)
Place the FT2A-CBLR-GR modules only at the ends of a module row.
l
Dress all cables after installing each module.
l
Pass-Through Cable Module
The FT2A-PLT-PT pass-through modules (sold separately) enable
FT2-CBL-PT pass-through cables (sold separately) and other types of
interface cables to be installed within the FT2-700-MECH-PTL. Each
FT2A-PLT-PT cable module is packaged with a nylon grommet and a
cable plate. An empty module slot in the FT2-700-MECH-PTL and an
FT2-CBL-PT series or other interface cable are required for installation.
Quick Start
series)
series, FT2A-CHGR series,
3