Crestron FlipTop FT2 Series Quick Start Manual page 5

FT2-700-MECH-PTL
FlipTop™ FT2 Series Cable Management System, 700 Size, Mechanical, Pass-Through Lid
5. Insert the cable plate into one of the three slots in the pass-through
module. Choose the appropriate slot based on the length of the cable
connector. The top of the connector must sit flush with the top of the
module.
NOTES:
If the connector extends past the top of the pass-through
l
module, the lid cannot close.
Ensure that the cable moves freely in the module prior to
l
attaching the side plate. The plate is difficult to remove once it is
attached.
6. Attach the side plate to the module by snapping the plastic clips on
the plate into the two slots on the module.
NOTE: When removing the side plate, use a flat-head screwdriver to
carefully pry the plastic clips off of the module near the two slots.
7. Feed the other end of the cable through an empty module slot in the
FT2 assembly.
8. Slide the pass-through cable module into the same module slot as
mentioned in the previous step. Use the guide ribs on the front and
rear of each module to help position the module in the FT2 assembly.
Quick Start
5