Oil Specification; Checking The Level Of The Engine Oil; Crankcase Oil Capacity; Changing The Engine Oil And Filter - Toro Reelmaster 5510 Operator's Manual

Traction unit
Hide thumbs Also See for Reelmaster 5510:
Table of Contents

Advertisement

Figure 75
2.
Close and latch the hood; refer to
Hood (page
44).

Oil Specification

Use high-quality, low-ash engine oil that meets or
exceeds API service category CH-4 or higher.
Use the following engine oil viscosity grade:
Preferred oil: SAE 15W-40 (above 0°F)
Alternate oil: SAE 10W-30 or 5W-30 (all
temperatures)
Toro Premium Engine Oil is available from your
authorized Toro distributor in either 15W-40 or 10W-30
viscosity grades.
Checking the Level of the
Engine Oil
Service Interval: Before each use or daily
Important:
Check the engine oil daily. If the
engine-oil level is above the Full mark on the
dipstick, the engine oil may be diluted with fuel;
If the engine oil level is above the Full mark,
change the engine oil.
The best time to check the engine oil is when the
engine is cool before it has been started for the day.
If it has already been run, allow the oil to drain back
down to the sump for at least 10 minutes before
checking. If the oil level is at or below the Add mark
on the dipstick, add oil to bring the oil level to the Full
mark. Do not overfill the engine with oil.
Important:
Keep the engine oil level between the
upper and lower limits on the oil gauge; the engine
may fail if you run it with too much or too little oil.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Open the hood; refer to
44).
3.
Check the level of the engine oil
g373569
Closing the
44).
Opening the Hood (page
(Figure
76).
Important:
Be sure to keep the level of
the engine oil between the upper and lower
limits on the oil gauge. Engine failure may
occur because of over filling or under filling
the engine oil.
4.
Close and latch the hood; refer to
Hood (page
44).

Crankcase Oil Capacity

Approximately 5.2 L (5.5 US qt) with the filter.
Changing the Engine Oil
and Filter
Service Interval: After the first 50 hours—Change
the engine oil and filter.
Every 150 hours
49
Figure 76
Closing the
g375802
g031256

Advertisement

Table of Contents
loading

This manual is also suitable for:

03964

Table of Contents