Pushing Or Towing The Machine - Toro Reelmaster 5510 Operator's Manual

Figure 56
1. Front tie-down
•
Rear of the machine—each side
of the machine on the rear frame
(Figure 57).
Figure 57
1. Rear tie-down
Pushing or Towing the
Machine
In an emergency, you can move the machine
forward by actuating the bypass valve in the
variable-displacement hydraulic pump and pushing or
towing the machine.
Important:
Do not push or tow the machine faster
than 3 to 4.8 km/h (2 to 3 mph). If you push or tow
at a faster speed, internal transmission damage
may occur.
The bypass valves must be open and the brake
released whenever you push or tow the machine.
1. Unlatch the seat base and tilt the seat open.
2. Locate the bypass valve under the seat and on
the top of the hydrostat
g031851
3. Loosen the valves with 3 turns to allow the oil to
bypass internally.
Note:
Because the fluid is bypassed, the
machine can be moved slowly without damaging
g004555
the transmission.
4. Locate the brake release manifold near the front
right tire and behind the hydraulic tank
59).
39
(Figure 58).
Figure 58
g420085
(Figure