Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Reelmaster 5510 Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
Download a free copy of the electrical or hydraulic schematic by visiting
for your machine from the Manuals link on the home page.

Maintenance Safety

•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage and lower the cutting units.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
– Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Wear appropriate clothing, including
eye-protection; long pants and substantial,
slip-resistant footwear. Keep hands, feet, clothing,
jewelry, and long hair away from moving parts.
•
Allow machine components to cool before
performing maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first hour
After the first 10 hours
After the first 50 hours
Before each use or daily
Every 50 hours
Maintenance Procedure
• Torque the wheel lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Torque the wheel lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Change the engine oil and filter.
• Check the engine speed (idle and full throttle).
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the interlock switches.
• Inspect the ROPS components for wear or damage.
• Check the air filter.
• Check the level of the engine oil.
• Drain water or other contaminants from the fuel/water separator.
• Check the electrical cables for damage, wear, loose fittings, weather deterioration,
and chemical deterioration.
• Check the tire air pressure.
• Check the coolant level.
• Remove debris from the screen, oil coolers, and radiator. (More frequently in dirty
operating conditions).
• Check the hydraulic-fluid level.
• Check the hydraulic lines and hoses for leaks, kinked lines, loose mounting supports,
wear, loose fittings, weather deterioration, and chemical deterioration.
• Check the reel-to-bedknife contact.
• Inspect the seat belt.
• Grease the bearings and bushings (and immediately after every washing).
• Clean the battery and check the condition of it (or weekly, whichever comes first).
• Check the battery-cable connections.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which
is lethal if inhaled.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
41
www.Toro.com and searching