Advertisement
Hardware Preparation and Installation
1
!
Warning
Preparing the Board
1-4
Turn the system's power off before you perform these
procedures. Failure to turn the power off before opening the
enclosure can result in personal injury or damage to the
equipment. Hazardous voltage, current, and energy levels are
present in the chassis. Hazardous voltages may be present on
power switch terminals even when the power switch is off.
Never operate the system with the cover removed. Always
replace the cover before powering up the system.
To produce the desired configuration and ensure proper operation of the
MVME162FX, you may need to reconfigure hardware to some extent
before installing the module.
Most options on the MVME162FX are under software control: By setting
bits in control registers after installing the module in a system, you can
modify its configuration. (The MVME162FX registers are described in
Chapter 3 under
ENV - Set
Embedded Controller Programmer's Reference Guide as listed in "Related
Documentation" in Appendix E.)
Some options, though, are not software-programmable. Such options are
controlled through physical installation or removal of header jumpers or
interface modules on the base board.
Environment, and/or in the MVME162FX
Computer Group Literature Center Web Site
Advertisement
