Advertisement
1Hardware Preparation and
Introduction
This chapter provides unpacking instructions, hardware preparation
guidelines, and installation instructions for the MVME162FX VME
Embedded Controller. Hardware preparation of the MVME712 series
transition modules compatible with this board is covered in separate
manuals.
Getting Started
This section supplies an overview of startup procedures applicable to the
MVME162FX. Equipment requirements, directions for unpacking, and
ESD precautions that you should take complete the section.
Overview of Installation Procedure
The following table lists the things you will need to do to use this board
and tells where to find the information you need to perform each step. Be
sure to read this entire chapter, including all Cautions and Warnings,
before you begin.
What you need to do...
Unpack the hardware.
Configure jumpers or serial
interface modules on the
MVME162FX as necessary.
Ensure that IP modules are
properly installed on the board.
Install the board in a chassis.
Connect a display terminal.
Table 1-1. Startup Overview
Guidelines for Unpacking on page 1-2.
Base Board Configurations on page 1-5.
IP Installation on page 1-19.
MVME162FX Installation on page 1-20.
Serial Connections on page 1-24.
Installation
Refer to...
1
1-1
Advertisement
