Table of Contents
Advertisement
U.K. Supplement to Operating Instructions for Elektra Beckum Band Saw BAS 600
Please note the following supplementary information associated with this machine:
U.K. Legislation and Codes of Practice
When used industrially within the U.K. this machine falls under the scope of
Woodworking Machines Regulations 1974
and
Use and Provisions of Work Equipment Regulations 1992
We strongly advise you study and follow these regulations.
Section 5 - Electrical Equipment/Connection to Power Mains
230 V motor. Although the motors supplied with this machine will run safely on a 13A domestic ring main, on starting
the machine a high current of very short duration is drawn, which could cause your 13A fuse to blow. If this persists
we recommend to have the machine connected to a 16A separate radial circuit using BS 4343 (CEE 17) plug and
socket. Ensure the installation is protected by a suitable fuse or miniature circuit breaker.
This work should be undertaken only by a qualified electrician!
If the plug, fitted to the power cable supplied with the machine, has to be changed or replaced, connect the mains lead
conductors in accordance with the following colour code.
Single-phase motors (110/115/220/230/240 volts):
Three-phase motors (220/380/400/415 volts):
Machines with a 3-phase motor are connected to power mains using a 5-pin industrial appliance-inlet/connector
according to
VDE 0623/BS 4343/IEC 309.
4-wire mains lead
5-wire mains lead
Wiring Instructions
Warning: This appliance must be earthed!
Yellow/green
Blue
Brown
Yellow/green
Brown
Black
Black
Yellow/green
Brown
Black
Black
Blue
I
-
F IN DOUBT
CONSULT A QUALIFIED ELECTRICIAN
-
Earth
-
Neutral
-
Live
-
Earth
-
Phase (L1)
-
Phase (L2)
-
Phase (L3)
-
Earth
-
Phase (L1)
-
Phase (L2)
-
Phase (L3)
-
Neutral
!
18
Advertisement
Table of Contents
