Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Elektra Beckum BAS 500 WNB
Summary of Contents for Elektra Beckum BAS 500 WNB
- Page 1 Betriebsanleitung Bandsäge Operating Instructions for Band Saw BAS 500 WNB Achtung! Lesen Sie diese Anleitung vor der Installation und Inbetriebnahme aufmerksam durch. Attention! Carefully read through these instructions prior to installation and commissioning.
-
Page 3: General Safety Information
The relief cuts are made before starting the curved cut. 31. NEVER LEAVE A TOOL UNATTENDED. Turn the power off and do not leave saw until it comes to a complete stop. 32. DISCONNECT POWER. Turn switch off and disconnect power whenever the band saw is not in use. - Page 4 In individual cases the machine can also be used to cut other materials. Written permission from the company Elektra Beckum AG (see the section below on product liability/warranty for the address) is required in such cases.
- Page 5 ● After the stop is adjusted, stick the rip fence scale (89) to the rip fence carrier (201). For a firm stand and vertical stability the saw must be bolted to the floor. Drilling pattern for anchor bolts.
-
Page 6: Safety Rules
Children and juveniles should not to operate this machine. This band saw is equipped with a 1.1 kW 230 V single- phase motor. For connection to power mains the power cable is fitted with an earthed plug. -
Page 7: Dust Collection
Machines with a 3-phase motor are connected to power mains using a 5-pin industrial appliance-inlet/connector according to VDE 0623/BS 4343/IEC 309. 4-wire mains lead Yellow/green 5-wire mains lead Yellow/green Instructions for Elektra Beckum Band Saw BAS 500 Wiring Instructions Yellow/green Earth...
Need help?
Do you have a question about the BAS 500 WNB and is the answer not in the manual?
Questions and answers