Table of Contents
Advertisement
What to do if "WARMING UP-PLEASE WAIT"
appears on the display.
This message indicates that the temperature
inside the camera has become extremely low.
The camera will be automatically restarted when
the inside the camera is warmed up by the built-in
heater. Please wait for a while.
We shall not be liable for content
compensation, losses of recorded or
edited content and any direct or indirect
consequent damages caused by failure to
record or edit due to faults with this unit or
the microSD memory card. In addition, the
same provisions apply after unit is reparied.
About the CMOS image sensor
• When continuously shooting a bright light
source such as a spotlight, the color filter of
the CMOS image sensor may become
deteriorated and this may cause
discoloration. Even when changing the fixed
shooting direction after continuously shooting
a spotlight for a certain period, the
discoloration may remain.
• When shooting fast-moving subjects or
objects crossing the shooting area may look
to be bending askew.
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury.
Do not use benzine, thinner, alcohol, or any other
types of solvents or detergents. Otherwise, it may
cause discoloration. When using a chemical cloth
for cleaning, read the caution provided with the
chemical cloth product.
• Do not loozen or remove screws unless
instructed to do so in the product
documentation.
Cleaning the lens
Use a lens cleaning paper (used to clean camera
lenses or lenses of spectacles). When using
solvent, use an alcohols solvent and do not use a
glass cleaner or a thinner.
Cleaning of the front panel
• When cleaning the front panel, hose or spray
fresh water that is not containing lubricant
agent or silicon substances and wash away
adherents such as grain of sand. If dirt is hard
to remove, use a sponge soaked into the
fresh water mentioned above and wipe off.
• Do not wipe the front panel with a dry cloth.
(Using dry cloth may spread oil constituent
adhered to the surface, and it may result in
damaging the ClearSight coating.)
• If dirt cannot be wiped off with a damp cloth,
use a neutral detergent for kitchen utensils,
and sufficiently rinse off the detergent. When
using a detergent containing wax
components such as determent for washing
cars, a detergent with polishing material such
as a compound, etc., and a non-neutral
(weakly acidic or weakly alkaline) detergent, it
can decrease the hydrophilic property and
peel off the surface coating.
• Do not use organic solvent such as benzine
and thinner.
• Before using a spray, abandon a few sprays
to eliminate impurities.
• Improper cleaning of the front panel may
cause the ClearSight coating to become less
effective. In this case, in order to have
effective ClearSight coating, a new front panel
must be purchased to replace the existing
front panel. Consult with your dealer or
construction contractor.
7
Advertisement
Table of Contents
