i-PRO WV-S1536LNSA Basic Information page 10

[2] Power supply cable / 2P power cable (WV-QCA501A accessory)
Connect the output cable of the DC power supply to the 2P power cable.
IMPORTANT:
• Be sure to use the 2P power cable provided with WV-QCA501A.
• Be sure to fully insert the 2P power cable into the power supply cable.
Otherwise, it may damage the camera or cause malfunction.
• When installing the camera, make sure that excessive force is not applied to the power cable.
• Be sure to use an AC adaptor compliant with the Specifications (written in the indication label
on the bottom side of this unit) regarding power source and power consumption.
[3] Audio input cable (white)
Connect a microphone or the line out of an external device using a stereo mini plug (ø3.5 mm).
<For microphone input>
• Recommended microphone (locally procured): Plug-in power type
(Sensitivity of microphone: –48 dB
• Input impedance:
• Supply voltage:
• Recommended cable length:
<For line input>
• Input level for the line input:
• Recommended cable length:
[4] Audio output cable (black)
Connect an external speaker* using a stereo mini plug (ø3.5 mm). (Audio output is monaural.)
• Output impedance:
• Recommended cable length:
• Output level:
IMPORTANT:
• Connect/disconnect the audio cables and turn on the power of the camera after turning off
the power of the audio output devices. Otherwise, loud noise may be heard from the speaker.
• Make sure that the stereo mini plug is connected to this cable. When a monaural mini plug is
connected, audio may not be heard.
When connecting a monaural speaker with amplifier, use a locally procured conversion cable
(mono-stereo).
3 dB (0 dB=1 V/Pa,1 kHz))
±
Approx. 2 kΩ (unbalanced)
2.5 V ±0.5 V
Less than 1 m {3.28 feet}
Approx. –10 dBV
Less than 10 m {32.8 feet}
Approx. 600 Ω (unbalanced)
Less than 10 m {32.8 feet}
–20 dBV
10
* Use a powered speaker.