Touch Screen Controls - Air Techniques MOJAVE LT3M User And Installation Manual

TOUCH SCREEN CONTROLS

Note: The motor power circuit breaker must be kept in the ON position to operate the color
LCD touch screen display. See Operating Information on page 15.
All MOJAVE LT units have a color LCD touch screen display located on the front control box panel .
This display is used to start the unit and show system operating status . It also serves as an input for
controlling operation and adjusting system parameters .
The display shows two screens during normal operation; a Home Screen and a Settings Screen . The
Home Screen is used to start and monitor operation of the MOJAVE LT, while the Settings Screen
allows changes to operating parameters .
The screens are comprised of operation Buttons, Navigation Buttons and Widgets as described below .
Standby Button
Vacuum Widget
Navigation Buttons
Operation Buttons
Standby Button - Home Screen Standby Button that when blue, indicates the system is in
the "Standby" mode . When pressed, this switch starts the compressor operation .
Running Button - Home Screen Standby Button that when green indicates the system is in
the "Running" mode . When pressed, this switch stops MOJAVE LT operation and returns
to the "Standby" (blue button) mode .
Error Button - Home Screen Standby Button that when red indicates an error is present
causing the MOJAVE LT to shut down operation .
Navigation Buttons - located on the bottom of the screen these buttons allow the user to migrate
within a screen by going to the next screen level or to transfer between the Home Screen and a
Settings Screen .
Widget - an element of a graphical user interface (gui) that is used to display information during
vacuum operation . The Home Screen normally shows the Vacuum Widget while the Motor Frequen-
cy, Separator RPMs, Voltage and Temperature widgets are accessed by pressing the Next Navigation
Button .
Page 16 Air Techniques, Inc.