Install The Router Without A Mechanical Lift - IBM J02M Quick Start Manual

Table of Contents

Install the Router Without a Mechanical Lift

NOTE: The area around the rack must be clear on all sides to allow full access to the

people lifting the chassis into place.

At least two people are required to lift an empty chassis, which weighs approximately

65.5 lb (29.5 kg), and mount it in a rack. To install the router without using a lift:

Slide the router onto the mounting shelf until the mounting brackets contact the

rack rails. The shelf ensures that the holes in the mounting brackets align with

the holes in the rack rails.

Move the lift away from the rack.

Install a mounting screw into each of the open mounting holes aligned with the

rack, starting from the bottom.

Visually inspect the alignment of the router. If the router is installed properly in

the rack, all the mounting screws on one side of the rack should be aligned with

the mounting screws on the opposite side, and the router should be level.

Ensure that the rack is in its permanent location and is secured to the building.

Position the router in front of the rack or cabinet, centering it in front of the

mounting shelf. Use a pallet jack if one is available.

With one person or two people on each side, hold onto the bottom of the chassis

and carefully lift it onto the mounting shelf.