Table of Contents
Advertisement
Maintenance
Service Schedule
Check machine for cord damage
Check recovery dome and gasket for damage and cleanliness
Check brushes - should be clean with no lint or strings attached
Clean the underside of the brush deck area
Observe spray pattern
Inspect vac shoe for blockage; Remove and rinse any debris
Check hoses for wear, blockages, or damage
Check handles, switches, and knobs for damage
Run one gallon of water through solution system at end of day
Clean out recovery tank, clean float screen and check float ball to
make sure it moves freely
Clean out solution tank
Clean outside of all tanks and check for damage
Run vacuum motor for at least one minute to allow motor to dry
Store with recovery dome and solution lid removed to allow the tank
to dry
Check drive wheels for damage and wear
Remove bearing cap from end of brush. Clean bearing and cap.
Check all bearings for noise
Check all gaskets for wear and leakage
Check and clean solution screen
Check brush for wear; ensure bristles are not damaged
Check condition of vacuum shoe and frame for damage
Remove the bearing end cap off of the brush and clean
Check overall performance of machine
Check belts for wear and replace as necessary
Check cables for fraying
Check pump pressure; observe spray pattern and check with gauge
if necessary
30
MAINTENANCE
8.645-280.0 Manual Operator Flotilla BRC 45-38
DAILY
WEEKLY
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
QUARTERLY
*
*
*
Advertisement
Table of Contents
