Table of Contents
Advertisement
4.6
Change Method Parameters
The input or modification of the method name was already described in 4.1 and 4.3
Fig. 57
Method type
4.6.1
On the «Method type» you can select whether you wish to perform a manual or automatic titration, a dosage or
whether you wish to prepare a solution.
Fig. 58
The selection of the Method type will have an influence on the further parameterisation of the method
For instance, if you select the dosing mode, neither a selection of a formula nor a change of the automatic
titration mode (KF and dead stop) will be available.
Titration mode
4.6.2
For an automatic titration, you can select from the following modes:
Linear titration (pH and mV)
Dynamic titration (pH and mV)
End-Point titration (pH, and µA)
In addition one can also carry out a measurement:
111
Advertisement
Table of Contents
